phone: 02-954-2408-9, 089-514-8111

หุ่นยนต์ AlphaBot, Basic robot building kit for Arduino

sku : EFDV610
This kit comes with controller board UNO PLUS, AlphaBot robotic platform (line tracking, obstacle avoidance, speed measuring, IR control), and ultrasonic sensor.
Only 3 left

สถานะของสินค้า : สินค้าพร้อมส่ง


With this product, you earn 90 loyalty point(s).



รหัส : EFDV610
ยี่ห้อ : Waveshare
รุ่น : SKU: 12257

Basic Robot Building Kit for Arduino: UNO PLUS + AlphaBot + Ultrasonic Sensor
ในเซ็ตประกอบด้วย บอร์ด UNO Plus + ชุดโครงรถ Alphabot + โมดูล Ultrasonic Sensor
(ไม่รวมโมดูล Bluetooth, Camera)

Note: This product requires two 18650 batteries to work,
which are NOT included and should be purchased separately.
(สินค้าชุดนี้ ไม่มีเเบตเตอรี่ให้นะคะ)

*** สนใจคอร์สอบรมสอนทำหุ่นยนต์ คลิกดูรายละเอียด!!! ***


This kit comes with controller board UNO PLUS, AlphaBot robotic platform (line tracking, obstacle avoidance, speed measuring, IR control), and ultrasonic sensor.

While utilizing UNO PLUS as controller board, this kit is based on the Arduino software/hardware open source platform. Combined with the modular design, it's an ideal platform to get started with Arduino robot.

Remark: UNO PLUS is a development board compatible with the Arduino UNO R3, an improved & enhanced alternative solution for Arduino UNO R3.

AlphaBot Features:

  • Raspberry Pi/Arduino interfaces, works with either one separately, or both
  • Arduino extend header, supports Arduino shields
  • Modular design, plug-and-play modules like line tracking, obstacle avoidance, speed measuring, etc. eliminating the trouble of connecting mess wires.
  • LM298P motor driver with diode protection circuit, more safety
  • LM2596 voltage regular, provides stable 5V power to the Raspberry Pi/Arduino
  • TLC1543 AD acquisition chip, allows the Pi to use analog sensors

What's on the UNO PLUS:

  • AMS1117-3.3 : 3.3V voltage regulator
  • NCP1117ST50T3G : 5V voltage regulator
  • FT232RL : USB to UART convertor
  • Arduino interfaceICSP interface
    • compatible with standard Arduino interface with two additional analog inputs A6 (config the CFG), A7
    • solder pads provided, supports prototype breadboard
  • MICRO USB connector : for uploading program OR serial port debugging
  • Power output header : 3.3V OR 5V, voltage level configured by the onboard power configuration switch, used as power output OR common-grounding with other boards
  • FT232 pins : for burning Bootloader into the microcontroller
  • DC input : 7V ~ 12V
  • Reset button
  • Power indicator
  • Serial port Rx/Tx indicator
  • User LED
  • Power configuration switch : for configuring the operating voltage
  • Bootloader selection switch
    • turn ON : the board will reset when power-up OR other USB devices were detected connecting to the PC
    • turn OFF : the onboard program runs immediately when power-up, and the board will not reset when other USB devices were detected connecting to the PC

What's on the AlphaBot Mainboard:

  • Raspberry Pi interface: for connecting Raspberry Pi
  • Arduino interface: for connecting Arduino
  • Motor interface
  • Ultrasonic module interface
  • Servo module interface
  • Obstacle avoidance module interface
  • Speed measuring interface
  • Battery holder: supports 18650 batteries
  • Reserved power input (not soldered): for connecting other external power supply
  • Arduino expansion header: for connecting Arduino shields
  • UART interface: for connecting Bluetooth module, to control the robot remotely via Bluetooth
  • SPI interface: for connecting NRF24L01 wireless module
  • Line tracking module interface
  • TLC1543: 10-bit AD acquisition chip, allows the Pi to use analog sensors
  • LM298P: dual H bridge motor driver chip, up to 2A current
  • Anti-reverse diode
  • Power switch
  • LM2596: 5V regulator
  • Power indicator
  • UART switch: turn on to enable serial communication between Raspberry Pi and Arduino
  • IR receiver: control the robot remotely via infrared
  • Raspberry Pi/Arduino selection: select the Raspberry Pi or Arduino to control the robot peripherals


Information Support:


Product included:
AlphaBot Standard:

  • AlphaBot mainboard x1
  • Tracker Sensor x1
  • Photo Interrupter Sensor x2
  • Infrared Proximity Sensor x2
  • Motor with gearbox 2PCS x1
  • AlphaBot wheel 2PCS x1
  • AlphaBot acrylic chassis x1
  • Motor mounting plate 4PCS x1
  • omni-direction wheel x1
  • 20-slots encoder disk 2PCS x1
  • IR remote controller x1
  • XH2.54 4cm 4Pin 2PCS x1
  • XH2.54 4cm 3Pin 2PCS x1
  • XH2.54 4cm 7Pin x1
  • AlphaBot screws x1

Additional Parts in the Kit:

  • UNO PLUS x1
  • Ultrasonic sensor x1
  • SG90 servo x1
  • Ultrasonic sensor adapter x1
  • Servo mounting plate x1
  • XH2.54 20cm 4PIN x1
  • USB type A plug to micro B plug cable x1




Country of Manufacture



Only registered users can write reviews. Please, log in or register

Memory usage: real: 20971520, emalloc: 20163040
Code ProfilerTimeCntEmallocRealMem